The Wolseley Forum

Welcome Guest ( Log In | Register )

 
Reply to this topicStart new topic
> Isis series II gearbox mounts
webmonster
post 15 Oct 2017, 23:07
Post #1


Wolseley Fanatic
Group Icon

Group: Morris Member
Posts: 1,962
Joined: 28-September 10
From: Taranaki
Member No.: 922
Proud citizen of: nz


The gearbox rubber mounts I've bought - the bottom plate is too narrow!
My parts manual says 1G9380 - a standard BMC mount for MGB, Oxford, AH etc. but it is not this.
The bolt centres need to be 73mm (2 7/8") across.

The only other listing is on a different page for the automatic gearbox and this mount is ACC8683. It looks wider in the diagram.
My Isis is a late one (1958) - I wonder if they ran out of manual gearbox cross members and modified automatic ones instead? They look almost identical.

Is ACC8683 still available anywhere?
The Isis auto is a Borg-Warner DG (I think...)
Go to the top of the page
PMEmail Poster  
+Quote Post
Danny
post 16 Oct 2017, 07:46
Post #2


Wolseley Fanatic
*******

Group: Forum Member
Posts: 1,886
Joined: 4-February 11
From: Sydney
Member No.: 1,742
Proud citizen of: au


The hole in the auto mounts is only 5/16".

Between hole centres of ones I took off a 6/90 recently (supposedly 1G9380) is 2 3/8" or 60 and a bit mm. I reckon 70mm / 2 3/4" would be the measure from the outer extremities of the bolt holes. Not measured with high tech equipment BTW.

Danny

This post has been edited by Danny: 16 Oct 2017, 07:51
Go to the top of the page
PMEmail Poster  
+Quote Post

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: 13th December 2017 - 15:03